Molding Intallation Necessary Tools

Crown molding is a decorative trim used to cover the top of a section of a wall. It’s a popular choice for interior designers as it can add both beauty and strength to any home. However, installing it correctly and safely can be a challenge. When it comes to molding installation, there are a lot of necessary tools and materials available. The following are a few that you will need for your job:

Caulk gun

A caulk gun is used to apply a waterproof sealant to a joint. beginners can use this to apply the caulk while a more experienced person can use various techniques to apply 2 to 3 layers of caulk in a more accurate manner.

Molding putty knife

This is a tool that has a flat end and a handle on one side, which makes it easier to apply the putty to the drywall’s edge. The flat end is used to spread the putty, while the handle is used to smooth the putty’s surface. A flathead screwdriver is used to apply the molding to the wall.

Molding knife

This is a long and thin knife that is used to cut the molding to the right size. This is done by making small, downward strokes until the proper size is achieved. The knife will often have a long handle, making it easier to make the cuts.

Tape measure

This is a helpful tool for insulating walls when it comes to crown  molding installation. It should be cut at the same height on both sides. This can be done by using a straight edge, which is also known as a surveyor’s square. Use tape to measure straight lines.

Nail Gun

A nail gun is a form of hammer used to drive nails into wood or other materials. Get yourself a nice nail gun – preferably one that doesn’t require a compressor. Go with 2-inch brad nails for crown, and try to mark your studs in advance so you can nail right into those.

If you are in need of molding installers, Neil Richardson Home Repair And Improvements is the right one for you. We also offer other services relative to this. Reach out at (352) 292-2014 for more details. Our office is located in Ocala, FL region.